Agilent Technologies 8753ET Manual Supplement

1-2
Supplement for the User’s Guide (Firmware Version 7.66)
Using This Chapter
Using This Chapter
This chapter contains the supplemental information changes to the user’s guides that
coincide with the release of firmware revision 7.66. These changes pertain to the following
user’s guides.
• 8753ET and 8753ES Network Analyzers User’s Guide (part number 08753-90472)
• 8753ES Option 011 Network Analyzer User’s Guide (part number 08753-90479)
The following list describes the changes to 8753ET and 8753ES user’s guides printed prior
to July 2000. Each of the changes are described in detail in the remainder of this chapter.
The page references in this list refer to page numbers in this supplement.
• Making Measurements Chapter
— Add the softkey after the softkey in all existing
locations.
— Add the softkey between the key and the
softkey in the section titled “Limit Test Example Sequence”
in “Using Test Sequencing to Test a Device” on page 1-5.
— Add “Using Ripple Limits to Test a Device” on page 1-7 to the chapter.
— Add “Using Bandwidth Limits to Test a Bandpass Filter” on page 1-17 to the chapter.
• Making Mixer Measurements Chapter
— Replace the section titled “Conversion Loss Using the Frequency Offset Mode” on
page 1-23.
• Printing, Plotting, and Saving Measurement Results Chapter
— Add a note referencing the new “Saving in Graphical (JPEG) Form” section after the
displayed paragraph in “To View Plot Files on a PC.”
— Add the new sections “Saving in Textual (CSV) Form” on page 1-33 and “Saving in
Graphical (JPEG) Form” on page 1-34 to the “Saving Measurement Results” section.
• Calibrating for Increased Measurement Accuracy Chapter
— Add a paragraph explaining the frequency entry to step 5 of “Calibrating for
Non-Coaxial Devices (ES Analyzers Only).”
— Append a note referencing the new “Saving Modified Calibration Kits to a Disk”
section to step 19 of the “Calibrating for Non-Coaxial Devices (ES Analyzers Only)”
section.
— Append a note referencing the new “Saving Modified Calibration Kits to a Disk”
section to step 19 of the “LRM Error Correction” section.
• Operating Concepts Chapter
— Append “Saving Modified Calibration Kits to a Disk” on page 1-37 to the end of the
section titled “Modifying Calibration Kits.”
LIMIT LINE
LIMIT MENU
RECALL KEYS
Save/Recall
RECALLKEYS MENU

Agilent Technologies 8753ET Specifications

General

Brand	Agilent Technologies
Model	8753ET
Category	Measuring Instruments
Language	English