6-2
Supplement for the Programmer’s Guide (Firmware Revision 7.68)
In This Chapter
In This Chapter
This chapter contains the supplemental information changes to the programmer’s guide
that coincides with the release of firmware revision 7.68. These changes pertain to:
The Programmer’s Guide for 8719ET/ES, 8720ET/ES, 8722ET/ES, and 8753ET/ES
Network Analyzers (part number 08753-90475)
IMPORTANT If you are upgrading your firmware from a revision prior to revision 7.66, add
the information changes from Chapter 3 , “Supplement for the Programmer’s
Guide (Firmware Revision 7.66),” before adding the changes from this
chapter.
The following list describes the changes to programmer’s guides printed prior to
February 2001. Each of the changes are described in detail in the remainder of this
chapter. The page references in this list refer to page numbers in this supplement.
• Alphabetical Command Reference Chapter
— Add the new command options to the existing CALI and CALK commands of the
“Alphabetical Command Reference” section. CALI has one new command option and
CALK has two new command options. See page 6-3.
— Add the 18 new ECal programming commands (page 6-5 through page 6-14) to the
“Alphabetical Command Reference” section.
• Appendix A: Preset Conditions
— Add enhanced reflection preset conditions from Table 6-1 to the existing “Calibration
Conditions” table. See page 6-15.
— Add Table 6-2, “Electronic Calibration (ECal) Conditions,”to the existing “Preset
Conditions” section. See page 6-15.
• Appendix B: Command Listings
— Add 21 new programming commands to the “Alphabetical List of Commands”
subsection of the “Command Listings” section. See page 6-17.
— Add 2 new programming commands to the “OPC-Compatible List of Commands”
subsection of the “Command Listings” section. See page 6-17.
To Next Page
Loading...
Need help?
General
