Getting Started 2
N9342C/43C/44C User’s Guide 13
Safety Considerations
Agilent has designed and tested the N934xC
handheld spectrum analyzer for measurement,
control and laboratory use in accordance with
Safety Requirements IEC 61010- 1: 2001, UL
61010- 1 (2004), and CSA C22.2 No.61010- 1- 04. The
tester is supplied in a safe condition. The N934xC
is also designed for use in Installation Category II
and Pollution Degree 2 per IEC 61010 and IEC
60664 respectively.
Read the following safety notices carefully before
you start to use a N934xC handheld spectrum
analyzer to ensure safe operation and to maintain
the product in a safe condition.
WARNING
Personal injury may result if the analyzer’s cover is
removed. There are no operator-serviceable parts inside.
Always contact Agilent qualified personnel for service.
Disconnect the product from all voltage sources while it
is being opened.
WARNING
This product is a Safety Class I analyzer. The main plug
should be inserted in a power socket outlet only if provided
with a protective earth contact. Any interruption of the
protective conductor inside or outside of the product is likely
to make the product dangerous. Intentional interruption is
prohibited.
WARNING
Electrical shock may result when cleaning the analyzer
with the power supply connected. Do not attempt to
clean internally.
Use a dry soft cloth to clean the outside
case only.
WARNING
Always use the three-pin AC power cord supplied with
this product. Failure to ensure adequate earth grounding
by not using this cord may cause personal injury and
product damage.
To Next Page
Loading...
