2 Getting Started
18 N9342C/43C/44C User’s Guide
Powering the Analyzer on for the First Time
Insert the battery into the analyzer or connect the
analyzer to an external power supply via the
AC- DC adapter, then press the power switch on
the front panel of your N934xC to power on the
analyzer.
Allow the analyzer to warm- up for 30 minutes
before making a calibrated measurement. To meet
its specifications, the analyzer must meet operating
temperature conditions.
CAU-CAUTION
Use only the original AC-DC adapter or originally supplied
battery for the power source.
The maximum RF input level of an average continuous
power is 30 dBm (or +
50 VDC signal input). Avoid
connecting a signal into the analyzer that exceeds the
maximum level.
Install battery
Press Power Switch
To Next Page
Loading...
