Getting Started 2
N9342C/43C/44C User’s Guide 19
Preparation for Use
This section provides the basic system
configuration which is frequently used before or
after the measurement operation.
Power On and Preset Settings
Selecting a preset type
Press [SYS] > {PwrOn/Off Preset} > {Preset Type} to
choose the preset types. The analyzer has three
types of preset setting for you to choose from:
DFT Restores the analyzer to its factory- defined
settings. The factory default settings can be
found, “Factory Default Settings" on page 20.
User Restores the analyzer to a user- defined
setting. Refer to the descriptions as below.
Last
Restores the analyzer to the last setting.
Saving a User-defined Preset
If you frequently use system settings that are not
the factory defaults, refer to the following steps to
create a user- defined system settings that can be
easily recalled:
1 Set the analyzer parameters using the knob, the
arrow keys, or the numeric keypad.
2 Press [SYS] > {PwrOn/Off Preset} > {Save User} to
save the current parameters as the user preset
setting.
3 Press [SYS] > {PwrOn/Off Preset} > {Preset Typ e Us er }
to set the preset mode to user defined system
setting.
4 Press [Preset]. The instrument will be set to the
state you previously saved.
To Next Page
Loading...
