Chapter 1 23
Getting Started
Setting Up Your Signal Analyzer and Signal Source
Getting Started
3. Press the MODE key followed by the Spectrum Analysis softkey to put
the PSA Series analyzer into Spectrum Analysis mode.
4. Press the Source key to display the
Ext Source menu.
5. Press the
Ext Src Config softkey to display the current value for the
IP address of an external signal source. If this IP address does not
match the IP address of your ESG-C or PSA signal source (from
Step 2 above), then you need to change it using Steps 6 and 7.
6. Press the
IP Address softkey so that the key label is highlighted.
7. Enter the IP Address of the ESG-C or PSG signal source using the
numeric keypad, and press the
Enter key.
NOTE If you are using a cross-over LAN cable to connect the instruments
directly together, then the IP addresses of both the instruments must
start with the same two integers. That is, if the spectrum analyzer IP
address is 156.121.12.122, the source IP address must be
156.121.xxx.xxx.
To Next Page
Loading...
Need help?
General
