Agilent Technologies PSA Series - Reference Trace Display

Chapter 4
Source Key and Programming Commands
Normalize
61
Source Key and Programming
Commands
4.5.5 Reference Trace Display
Mode: Spectrum Analysis
Key Path:
Source, Normalize
Factory Preset: Blank
State Saved: Saved in instrument state.
Dependencies and
Couplings:
Parameter is disabled if active mode is not Spectrum Analyzer
or a connection has not been established at the specified IP
address.
When the reference trace is set to View, trace normalization is
turned OFF, and Trace 3 (the reference trace) is placed into
View mode.
Remote Command
Notes:
No SCPI. Front Panel only.