Agilent Technologies PSA Series User Guide

Chapter 4
Source Key and Programming Commands
External Source Configuration
49
Source Key and Programming
Commands
4.1.4 Serial Number
Information parameter which displays the serial number of the signal source connected at the specified IP
Address. The serial number displayed will be determined by sending a “*IDN?” to the entered IP address.
The serial number is the third field of the “*IDN?” returned value (Format of the *IDN? string is
‘<Company Name>, <Model Number>, <Serial Number>, <Firmware Revision>’).
4.1.5 Start Frequency
Information parameter which displays the start frequency of the signal source connected at the specified IP
Address.
Mode: Spectrum Analysis
Key Path:
Source, Ext Src Config, Show Setup
Factory Preset: ------
State Saved: No
Notes: This parameter is not user definable and is provided purely for
information. It is simply displaying the serial number of the
instrument recognized to be at the IP Address you entered.
Remote Command
Notes:
Front panel information only
Mode: Spectrum Analysis
Key Path:
Source, Ext Src Config, Show Setup
Remote Command: :SOURce:EXTernal:FREQuency:STARt?
State Saved: No
Dependencies and
Couplings:
The external source start frequency is changed each time the
start frequency of the PSA changes.
If the calculated external source start frequency exceeds the
frequency range of the external source Error Message 13227
will be reported and the sweep stopped until you adjust either
PSA Start Freq, PSA Stop Frequency, Frequency Offset (if ON)
or Harmonic (if ON) such that the frequency range can be swept
by the signal source and PSA simultaneously.
Remote Command
Notes:
Query only
Example: SOUR:EXT:FREQ:STAR?

Agilent Technologies PSA Series Specifications

General

Brand	Agilent Technologies
Model	PSA Series
Category	Measuring Instruments
Language	English