Chapter 5 67
Hints and Tips
FAQs and Helpful Hints and Tips
Hints and Tips
therefore be slightly offset from the frequency limits of the source.
You can increase the number of sweep points or decrease the span of
the sweep to get closer to the frequency limit of your signal source,
but you will never be able to get right to the limit. See “Further
Frequency Limitations” on page 9 for a more detailed discussion of
this limitation.
•
Signal Source IP Address Connection Problem - if you are using a LAN
cross-over cable to connect the spectrum analyzer to the source
directly, then the IP address of both instruments must start with the
same first two integers. For example, if your analyzer IP address is
156.121.102.33, then your source IP address must be set to
156.121.xxx.xxx.
To Next Page
Loading...
