Agilent Technologies VGA 77 - Installation Checklist

Getting Started
Agilent Vapor Generation Accessory VGA 77 and VGA 77P User’s Guide 19
Figure 1. VGA 77 with AA module installed
Installation Checklist
Use the following checklist to help you complete each step of the
installation.
 Check that the correct gas supply is available and then connect
your VGA 77 to the supply. See Page 20.
 Check that the correct power supply is available, the correct
fuses are installed and that the voltage selector is correctly set.
See Page 22.
 Check the environmental requirements. See Page 15.
 Install the pump unit. See Page 24.
 Install the reagent module. See Page 24.
INERT GAS ‘A’
INERT GAS ‘B’
LOW GAS
PRESSURE
SAMPLE
ACID
RED
REDUCTANT
ACID
SAMPLE
INERT GAS "A" TO
REACTION COIL
INERT GAS "B" TO SEPARATOR
sample
acid
reductant