Spa
10
1.3 NOISE LEVEL
LpA 85dB - LWA 102dB Directive 86/662/CEE
1.4 STORAGE - GARAGING
If the machine is not used for long periods it must be stored in a sheltered area
protected from weather and against damage. Before storage, it is recommended that
the machine be thoroughly cleaned and that all mechanical parts be adequately
greased to protect them from rust.
Before putting the machine into storage for long periods it is best to do the following:
Remove any fodder remaining inside the mixing tank;
Carefully clean the machine inside and outside;
Do an overall visual inspection of the machine to see if there is any structural
damage or deep scratches in the paint, check to see if the original safety
pictographs are in the right positions and are whole and legible;
Grease all the mechanical components, the fastening pins;
Store the machine, if possible, in a covered room on a flat surface;
Remove the ignition key;
Apply the parking brake.
Used oil must be properly collected and must not be released into the
environment; according to the laws in force, it is classified as a hazardous
waste, and as such it must be brought to a special collection center.
Contact the “Exhausted Oils Mandatory Consortium” for the mandatory
collection of exhausted oil
1.5 RECOMMISSIONING THE MACHINE AFTER A LONG PERIOD OF
STORAGE
Before using the machine after a long period in storage, the following must be done:
Check the machine for any damage;
Check the mechanical components, which must be in good condition and free
from rust;
Check the oil levels in the motor and hydraulic system;
Check the tires for wear;
Check the lights and electrical system to make sure they are working properly;
The SITREX S.p.A. company will not be liable for any damages or injuries caused by
improper or inappropriate use of the machine.
To Next Page