Spa
62
4.5 TIRE REPLACEMENT
To replace a tire, proceed as follows:
Take the machine to a level surface and switch off the engine.
Use a suitable wrench to loosen all the wheel lug nuts one half turn.
Insert a suitable jack (with a load bearing capacity of at least 4,000 kg) under the
chassis near the tire to be replaced.
Raise the machine until the tire is no longer touching the ground.
Remove the lug nuts and the conical washers and check that the conical washers are
undamaged. If not, replace them to avoid damage to the wheel studs on the hub. Put
the nuts back on the studs without fully tightening them.
Lower the machine.
Tighten the nuts in an alternating pattern to 393 Nm torque (40Kgm).
The tire should be replaced when the machine is unloaded, if possible.
4.6 WELDING
Before doing any type of welding, use the special handle on the rear right-hand side of the
machine to disconnect the battery in order to avoid serious damage to the electrical system
and to all the electronic components (pg. 44).
4.7 REPLACEMENT OF CUTTER KNIVES
If you need to replace one knife, we recommend that you replace the entire set.
Using non-original replacement parts can cause machine vibrations and problems.
As this is a dangerous operation, replacement of the knives must be carried out only by
specialized personnel.
4.8 REPLACEMENT OF AUGER KNIVES
As this is a dangerous operation, you are advised to contact your dealer to ask
for qualified personnel to carry out the operation.
A WARNING: WEAR CUT-RESISTANT OVERALLS AND GLOVES
DANGER: extremely sharp knives, which also need special protective covering on the
blades to avoid causing serious injury.
To Next Page
Loading...