Spa
32
3.9 LOADING
Before starting loading operations with the cutter, the operator must make
sure there are no persons, animals or objects near the machine that may be
struck by materials thrown accidentally by the machine.
Below is the list of the recommended sequence in which the products should be
loaded:
Fibrous products such as straw, hay.
Silage products
Meal products, pellets or cereals.
Any liquid products.
It is also possible to load entire cylindrical or rectangular bales, first eliminating of
course the baling wire or twine, unloading slowly into the center of the tank to avoid
any possible damage to the auger.
If the bales are being loaded from the top of the tank, there should be no
one inside the cab or near the machine
To begin the loading of the MAXI mixer feeder with the cutter, proceed as follows:
Set the weighing control unit inside the cab.
Start the machine and let the diesel motor warm up for a few minutes.
Bring the machine near the product to be loaded.
Press buttons n° 7+13 (pg. 19) to start the mixing auger at low speed (10/15
RPM).
Raise the cutter to the height required, adjusting the height with the joystick.
Open the cutter rotor protective guard using buttons n° 3+13 (pg.19).
Start the cutter rotation pressing buttons n° 2+13 (pg.19) (the button can be
released after being pressed, but keep the “hold to run” button held down) on
the joystick and regulate the lowering of the cutter with the angle of the
joystick.
Depending on the product, three cutting modes can be set, setting for each one
the number of RPMs of the diesel engine.
Press button n° 5 on the control panel and enter the page for setting the “load
mode” and press the “ENTER”
button.
To Next Page
Loading...