Spa
33
When you have entered the page (FIG.1) set the three RPM parameters using
buttons 3 and 4 to increase or decrease the RPMs (FIG.1 -A-) and the up and
down arrows to move to the next mode (FIG.1 -B-) of the diesel engine that
you will then choose (depending on the product to be cut) by means of the
joystick, where pressing once button n° 2+13 (pg.19) you will have the first
calibration of the diesel, twice the second and three times the third.
For example:
1. - 900 RPM – meal, pellets, etc.
2. –1800 RPM – hay, straw or fibrous products.
3. –2400 RPM – silage products.
FIG.1
When you have completed the setting, press the "SAVE"
key to save
the settings.
To decrease the speed of the cutter, for example if you are in mode three and
you want to return to mode two, press button n° 1 while keeping the “hold to
run” button (n° 13) pressed (pg.19).
I If the cutter rotor gets overloaded and jams, hold down button 5 for more
than two seconds; in this manner, the cutter will turn in the opposite direction for
cleaning, and when releasing the button it will return to the number of RPMs set
before getting jammed, ready to continue the loading operation.
Close the cutter rotor protective guard using button n° 4+13 (pg.19).
To Next Page
Loading...