Spa
30
Starting procedure:
Make sure that the gear lever is in the neutral position and the auger is not in gear.
Turn the key on the steering column to turn on the starter.
After starting let the diesel motor heat up for a few minutes, depending on the outside
temperature.
If the diesel motor does not start, do not keep the starter on. Wait two or three
minutes and try again. If the motor still does not start, see the “Troubleshooting”
chapter and the motor manual.
Stopping procedure:
When work is done, let the diesel motor idle for a few minutes for the cooling and
correct lubrication of the turbo. Turn the key and remove it.
Never leave the key in the on position because it causes damage to the battery and the
warning lights.
All data, errors or warnings concerning the diesel engine will be shown on the John
Deere display (FIG.1).
FIG.1
FIG.2
In addition, by pressing button 8 (FIG.2) on the control panel and then “ENTER”
you can see data regarding the:
Diesel engine water temperature.
Intercooler air temperature.
Diesel engine oil pressure.
Hydraulic oil temperature.
Total machine working hours.
To Next Page
Loading...