EasyManua.ls Logo

Aichi SR12C - Page 38

Aichi SR12C
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
󱒨󱓍󱓆󱓕󱓙󱓊󱓗󱒅󱒝󱒅󱒒󱒅󱒴󱓕󱓊󱓗󱓆󱓙󱓎󱓔󱓓
32
NOTICE
Beforeoperatingthemachineforthe
firsttimeatthestartofwork,orduring
checks,makesurethattherotationlock
pinisunlocked.(Seefig.8‒2)
Rotationislocked Unlocked
M0858121
fig.8‒2
󱒸󱓙󱓊󱓕󱒅󱒗
Makesurebothoftheupperandlower
emergencystopbuttonarepulledoutto
“ON.”
M085M221
EmergencyStopButton
fig.8‒3
M082M323
EmergencyStopButton
fig.8‒4
󱒸󱓙󱓊󱓕󱒅󱒘
Operatetheenginestartswitch
upto“ENGINESTART”without
operatingtheenableswitchto
starttheengine.
Immediatelyreleaseyourhand
fromtheenginestartswitchoncetheengine
hasstarted.
M082L622
EngineStartSwitch Pre-heatLight
fig.8‒5
NOTICE
• Donotholdtheenginestartswitch
upfor15secondsormore.Failure
toreleaseyourhandcouldresultin
damagetothestartermotor.
• Taketheintervalof30secondsormore
beforere-startingtheenginetoprevent
damagingtheengine.
󱒸󱓙󱓊󱓕󱒅󱒙
Iftheenginedoesnotstarteasily
becauseofthecold,startthe
engineafterthepre-heatlight
hasgoneoff.
󱒸󱓙󱓊󱓕󱒅󱒚
Afterstartingengine,idletheenginefor
about5minutesforwarmingup.
NOTICE
Iftheoutsideairtemperatureisbelow
thetemperaturerangeforthehydraulic
oilusedinthemachine,travelthe
machineinawarmplaceuntilthe
hydraulicoiliswarmenough,andthen
dotheoutsidework.
󱒸󱓙󱓊󱓕󱒅󱒛
Checkthefuellevellight.
Whenthereislittlefuel
remaining,thislightwillbelit.
Onalevelsurface,itlightsat
about30liters.
Ifthefuellevellightison,addfuel(Referto
Chapter12fordetails).

Table of Contents

Related product manuals