EasyManua.ls Logo

Aichi SR12C - Hoisting with Boom Raised

Aichi SR12C
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
󱒨󱓍󱓆󱓕󱓙󱓊󱓗󱒅󱒖󱒕󱒅󱒒󱒅󱒹󱓗󱓆󱓓󱓘󱓕󱓔󱓗󱓙󱓎󱓓󱓌󱒅󱒲󱓊󱓙󱓍󱓔󱓉
45
HoistingwithBoomRaised4.
Whenyouareworkinginacrampedlocation,
youmaynothaveenoughroom
tolowertheboompriorto
hoisting.Insuchcases,itis
permissibletohoistthemachine
whiletheboomisstillup.Proceed
asfollows.
• Slingchainsorwireropesusedforhoisting
shouldbeatleast10meterslong.
• Settheboomangleto60°orlower(thatis,at
least10°belowthemaximumraiseangleof
70°).
• Ifslingchainsorwireropescontactthe
boom,placepadsontheboomtoprotectit.
M0858500
60°
Pads
1680mm
*Thisfigureshowsthe
gravitycenteratthe
boomangleof60
degrees.

Table of Contents

Related product manuals