This page is used for defining a single channel.
You have to define:
- Start Bit
- Number of Bits
- Name - to be used in Analysis
- Short Name - to be used on the display
- Function
- Max Acquisition Frequency
- Unit of Measure
- Protection ( in this case, the License Code you have previously set is used
- Stepped Value - this field is used in Analysis: if a value is Stepped, it is not interpolated (for example, the
Gear Number, that is to be shown at fixed values).
- Conversion : for every channel you can define a Gain and an Offset ( Output = Input Value x Gain + Offset)
or an Encoding. In this case, a conversion table is to be defined per every value of the field:
To Next Page
Loading...