Airo A Series - Default Chapter; Table of Contents

Use and Maintenance Manual – A12 JE A15 JE A17 JE A12 JED A15 JED Series
Page 3
Contents:
1. INTRODUCTION .......................................................................................................................................... 6
1.1. Legal aspects ............................................................................................................................................................. 6
1.1.1. Delivery of the machine ............................................................................................................................................... 6
1.1.2. Declaration of commissioning, first check, further periodical checks and transfers of ownership ................................ 6
1.1.2.1. Declaration of commissioning and first check .............................................................................................................. 6
1.1.2.2. Further periodical checks ............................................................................................................................................. 7
1.1.2.3. Transfers of ownership ................................................................................................................................................ 7
1.1.3. Operator training and information ................................................................................................................................ 7
1.2. Tests performed before delivery .............................................................................................................................. 7
1.3. Intended use ............................................................................................................................................................... 7
1.3.1. Leaving at height.......................................................................................................................................................... 8
1.4. Description of the machine ....................................................................................................................................... 8
1.5. Control panels ............................................................................................................................................................ 9
1.6. Drive power ................................................................................................................................................................ 9
1.7. Machine life, demolition and decommissioning. .................................................................................................... 9
1.8. Identification............................................................................................................................................................. 10
1.9. Location of main components ................................................................................................................................ 11
2. TECHNICAL FEATURES OF STANDARD MACHINES ............................................................................ 12
2.1. Model A12 JE............................................................................................................................................................ 12
2.2. Model A15 JE............................................................................................................................................................ 15
2.3. Model A17 JE............................................................................................................................................................ 18
2.4. Model A12 JED ......................................................................................................................................................... 21
2.5. Model A15 JED ......................................................................................................................................................... 24
2.6. Vibrations and noise ................................................................................................................................................ 27
3. SAFETY PRECAUTIONS .......................................................................................................................... 28
3.1. Personal protective equipment (PPE) .................................................................................................................... 28
3.2. General safety norms .............................................................................................................................................. 28
3.3. Use instructions ....................................................................................................................................................... 29
3.3.1. General ...................................................................................................................................................................... 29
3.3.2. Handling ..................................................................................................................................................................... 29
3.3.3. Operating procedures ................................................................................................................................................ 30
3.3.4. Wind speed according to Beaufort scale.................................................................................................................... 31
3.3.5. Pressure of the machine on ground and load-bearing capacity of ground ................................................................. 32
3.3.6. High-voltage power lines ............................................................................................................................................ 33
3.4. Dangerous situations and/or accidents ................................................................................................................. 33
4. INSTALLATION AND PRELIMINARY CHECKS ....................................................................................... 34
4.1. Becoming acquainted with the machine ................................................................................................................ 34
4.2. Preliminary operation checks ................................................................................................................................. 34
5. USE INSTRUCTIONS ................................................................................................................................ 35
5.1. Platform control panel ............................................................................................................................................. 35
5.1.1. Drive and steering ...................................................................................................................................................... 37
5.1.2. Platform positioning movements ................................................................................................................................ 38
5.1.2.1. Pantograph (lower boom) lifting/lowering ................................................................................................................... 38
5.1.2.2. Upper boom lifting/lowering ....................................................................................................................................... 38
5.1.2.3. Jib lifting/lowering. ...................................................................................................................................................... 38
5.1.2.4. Telescopic boom extension/retraction ....................................................................................................................... 38
5.1.2.5. QUICK UP/QUICK DOWN (optional) ........................................................................................................................ 39
5.1.2.6. Turret orientation (rotation) ........................................................................................................................................ 39
5.1.2.7. Jib rotation (optional) ................................................................................................................................................. 39
5.1.2.8. Platform rotation......................................................................................................................................................... 39
5.1.2.9. Platform levelling ........................................................................................................................................................ 39
5.1.3. Other functions of the platform control panel ............................................................................................................. 40