Airo A Series - General Maintenance

Use and Maintenance Manual – A12 JE A15 JE A17 JE A12 JED A15 JED
Series
Page 56
7.2. General maintenance
The table below indicates the main maintenance operations and their frequency. The machine is equipped with a service
hour-meter.
Operation
Frequency
Screw tightening (see paragraph "Various adjustments")
After the first 10 working hours
Oil level check in hydraulic tank
After the first 10 working hours
Check of the battery state (charge and liquid level)
Every day
Check of deformation of tubes and cables
Every week
Check of stickers and code plates
Every month
Articulated joints and sliding blocks greasing
Every month
Diesel motor generator fixing on elastic supports
Every month
Emergency devices efficiency check
Every year
Electric connections check
Every year
Oil level check in hydraulic tank
Every year
Hydraulic connections check
Every year
Periodic operation check and structure visual check
Every year
Screw tightening (see paragraph "Various adjustments")
Every year
Operation check of movement circuit pressure relief valve
Every year
Brake system operation check
Every year
Operation check of the turret inclinometer
Every year
Operation check of platform overload controller
Every year
Operation check of M1 microswitches
Every year
Operation check of PS1A-PS1B proximity sensors
Every year
MPT1 and MPT2 microswitches operation check
Every year
Operation check of dead-man pedal safety system
Every year
Telescopic boom sliding blocks clearance adjustment
Every year
Hydraulic filter replacement
Every two years
Total oil change in hydraulic tank
Every two years
Check of the pot-hole structure in case either wheel rides over a pothole
Immediately in case of ride over a
pothole.
ELECTRIC-DIESEL MODELS (E/D): Refer to the manufacturer's manual of the engine for any maintenance
operation.
TO SEND THE MACHINE TO THE MANUFACTURER WITHIN 10 YEARS OF WORK FOR A COMPLETE
CHECK