Connect to the power mains having the following features:
- Power voltage 230V ± 10%
- Frequency 50÷60 Hz
- Activated grounding line.
- Working protection devices according to current standards in force.
- Do not use extension leads exceeding 5 metres to connect to the mains.
- Use a cable of suitable section (min 3x2.5 mm
2
).
- Do not use rolled-up cables.
5.8. Level and refuelling (models A12 JED - A15 JED)
Before using the thermic drive power (Diesel motor generator) check the fuel level in the tank.
This operation is to be carried out by visually checking the fuel level through the visual level on the tank.
▪ Visually check the fuel level before starting to work.
▪ Keep the fuel tank and the motor clean.
5.9. End of work
After stopping the machine according to the instructions given in the previous paragraphs:
▪ Always set the machine to rest position (platform completely lowered).
▪ Press the emergency Stop button on the ground control panel.
▪ Remove the keys from the control panel to prevent unauthorized people from using the machine.
▪ Recharge the battery according to the instructions given in section "Maintenance".
▪ To fill the tank (if it applies).
To Next Page
Loading...