Use and Maintenance Manual – A12 JE A15 JE A17 JE A12 JED A15 JED
Series
WARNING!
After charging, when the battery charger is still connected, the electrolyte density values should
range from 1.260 g/l to 1.270 g/l (at 25thC).
To use the battery charger follow these procedures:
▪ connect the battery charger by means of plug A to a current socket with the a.m. features
▪ Check the connection state of the battery charger through led B. If it is on, connection has taken place and charging
has started. The colour and enable mode of the led indicate the battery charging phase (refer to table below).
RED led flashing for a few seconds
Battery charger self-diagnostic phase
Indicates that the battery charging has started
Indicates that the battery charging has reached 80%
Indicates that the battery charging has reached 100%
With the battery charger ON, the machine is automatically off.
To disconnect the battery charger from the power source, disconnect the machine from the electric line.
WARNING!
Before using the machine check that the power cord of the battery charger is disconnected.
To Next Page
Loading...