Akuvox R20A Admin Guide

13
7.2.LED Display Status
LED display adjustment is used to display the light changes of the call button in
the six statuses - normal(idle), offline, calling, talking and receiving a call. and the
user can also verify the current mode of the device through the LED status. To
set up on device web Intercom > LED Setting > LED Status interface.
The default LED Display Status:
Parameters Set-up:
● State: there are five states: Normal, Offline, Calling, Talking and
Receiving.
Note:
● Start Time and End Time will not be displayed unless you select
Specific Time for your LED mode.
LED Status
Description
Blue
Always on
Normal status
Flashing
Calling
Red
Flashing
Network is unavailable
Green
Always on
Talking on a call
Flashing
Receiving a call
Pink
Flashing
Upgrading
AKUVOX SMART INTERCOM www.akuvox.com

Akuvox R20A Specifications

General

Audio	Built-in Microphone and Speaker
Installation	Wall-mounted
Ingress Protection	IP65
Card Reader	13.56MHz, Mifare
RS485	Yes
Camera	2MP
Network	10/100Mbps Ethernet
Protocols	SIP
Power	PoE or 12V DC
PoE	IEEE 802.3af
Relays	1
Input	2