● Mode: select “Power on”, if you want the device to perform Autop every time
it boots up. Select “Repeatedly”, if you want the device to perform autop
according to the schedule you set up. select “Power On + Repeatedly” if
you want to combine Power On Mode and Repeatedly mode that will enable
the device to perform Autop every time it boots up or according to the
schedule you set up. select “Hourly Repeat” if you want the device to
perform Autop every hour.
● Schedule: if “Repeatedly” is selected, you can set up the time schedule for
the AutoP.
22.4.PNP Configuration
Plug#and#Play#(PNP)#is#a#combination#of#hardware#and#software#support#that#ena
bles# a# computer# sy s t e m# to# r e c o g ni z e# and# a d a p t# to# h a r dw a r e
configuration# changes# with# little# or# no# intervention# by# a# user. To do this
configuration on web Upgrade > Advanced > PNP Option interface.
22.5.Static Provisioning Configuration
You can manually set up a specific server URL for downloading the firmware or
configuration file. If an autop schedule is set up, the door phone will perform the
auto provisioning at a specific time according to Autop schedule you set up. In
addition, TFTP, FTP, HTTP, and HTTPS are the protocols that can be used for
upgrading the device firmware and configuration.
To Next Page
Loading...
Need help?
General
