Akuvox R20A Admin Guide

95
23.4.KeyKing Setting
To integrate KeyKing lift controller, you are required to set up the KeyKing
address obtained from your solution provider. You can navigate to Intercom > Lift
Control > KeyKing Advance Setting.
Parameter Set-up:
KeyKing Address: enter the KeyKing address provided by your solution
provider. The address number must be identical with the address number on the
lift controller board.
23.5.Akuvox EC32 Lift Controller
You are required to configure Akuvox EC32 before you can connect the door
phone to the lift controller. You can navigate to Intercom > Lift Control >
Akuvox EC32 & ZKT Advance Setting.
Note:
● Please consult with Akuvox technical support if you have any
inquiries on the integration mode of any OEM lift controller
integration project.
AKUVOX SMART INTERCOM www.akuvox.com

Akuvox R20A Specifications

General

Audio	Built-in Microphone and Speaker
Installation	Wall-mounted
Ingress Protection	IP65
Card Reader	13.56MHz, Mifare
RS485	Yes
Camera	2MP
Network	10/100Mbps Ethernet
Protocols	SIP
Power	PoE or 12V DC
PoE	IEEE 802.3af
Relays	1
Input	2