server type, therefore you are allowed to choose Cloud, SMDC in discovery
mode.
● Discovery Mode: click “Enable” to turn on the discovery mode of the device
so that it can be discovered by other devices in the network, and click
“Disable” if you want to conceal the device so as not to be discovered by
other devices.
● Device Address: specify the device address by entering device location
information from the left to the right: Community, Unit, Stair, Floor, Room in
sequence.
● Device extension: enter the device extension number for the device you
installed.
● Device Location: enter the location in which the device is installed and used.
9.4.Device Local RTP configuration
For the device network data transmission purpose, the device needs to be set up
with a range of RTP ports (Real-time Transport Protocol) for establishing an
exclusive range of data transmission in the network. Path: Network > Advanced
> Local RTP interface.
Parameter Set-up:
● Min RTP Port: enter the Port value in order to establish the start point for the
exclusive data transmission range.
● Max RTP port: enter the Port value in order to establish the end point for the
exclusive data transmission range.
To Next Page
Loading...
Need help?
General
