Parameter Set-up:
● Status: check to see if the SIP account is registered or not.
● Account: select the exact account (Account 1&2) to be configured.
● Account Enabled: click Enable or Disable to activate or deactivate the
registered SIP account.
● Display Label: configure the device label to be shown on the device screen.
● Display Name: configure the name, for example, the device’s name to be
shown on the device being called to.
● Register Name: enter the SIP account register Name obtained from the SIP
account administrator.
● User Name: enter the user name obtained from SIP account administrator.
● Password: enter the password obtained from the SIP account administrator.
10.4.SIP Server Configuration
SIP servers can be set up for device in order to achieve call session through SIP
servers between intercom devices. To do this configuration also on web Account
> Basic > SIP Server interface.
To Next Page
Loading...
Need help?
General
