Administrator’s Guide for Akuvox SP-R5xP IP Phones
Akuvox Proprietary and Confidential. Copyright © 2014 Akuvox network Co., Ltd..
Page 145 of 221
This chapter provides the detailed information on how to customize the following resource files
and specify the access URL:
Local Contact File
You can add contacts one by one on the IP phone directly. You can also add multiple contacts at a
time and/or share contacts between IP phones using the local contact template file. After setup,
place the template file to the provisioning server and specify the access URL of the template file
in the configuration files.
When editing a local contact template, learn the following:
<ContactData> indicates the start of a contact list and <ContactData> indicates the end of a
contact list.
</Group> indicates the start of a group list and </Group> indicates the end of a group list.
When specifying a ring tone for a contact or a group, the format of the value must be Auto (the
first registered line), Resource:RingN.wav and Bellcore-drN.wav(system ring tone, integer N
ranges from 1 to 9 for RingN.wav, from 1 to 5 for Bellcore-drN.wav) or Custom:Name.wav (custom
ring tone).
When specifying a desired line for a contact, the valid values are 0 and line ID, 0 stands for the
first available account. Multiple line IDs are separated by commas.
At most 5 groups can be added to the IP phone.
At most 500 local contacts can be added to the IP phone.
Procedure
Use the following procedures to customize a local contact template file.
To customize a local contact file:
1. Open the template file using an ASCII editor.
2. For each group that you want to add, add the following string to the file. Each starts
on a separate line:
<Group Id="" Name="" Ring="" Description="">
Where:
Name="" specifies the name of the group.
Ring="" specifies the desired ring tone for this group.
3. For each contact that you want to add, add the following string to the file. Each starts on a
separate line:
To Next Page
Loading...
Need help?
General
