Administrator’s Guide for Akuvox SP-R5xP IP Phones
Akuvox Proprietary and Confidential. Copyright © 2014 Akuvox network Co., Ltd..
Page 33 of 221
3. Click Submit to accept the change
A dialog box pops up to prompt that router setting: required to reboot to make changings
take effect, are you sure to reboot
4. Click OK to reboot the IP phone
To configure the PC port mode via phone user interface:
1. Press Menu > Settings > Advanced Setting (password: admin) > Network > PC Port
2. Select the desired mode.
If you select Router, you can configure the IP address for the PC port and configure
DHCP for the PC attached to the PC port.
1) Enter the IP address in IP Address field.
2) Enter the subnet mask in the Subnet Mask field.
3) Press Left or Right to enable DHCP Server.
4) Enter the start IP address in the Start IP field.
5) Enter the end IP address in the End IP field.
3. Press Save to accept the change
A dialog box pops up to prompt that phone restart, please wait. Settings will take
effect after a reboot
Upgrading Firmware
This section provides information on upgrading the IP phone firmware. Two methods of
firmware upgrade:
Manually, from the local system for a single phone.
Automatically, from the provisioning server for a mass of phones.
To Next Page
Loading...
Need help?
General
