7.16.6 Reconnect your deskphone in remote place
Your phone is already configured for teleworking but it was connected in your place of business. You
need to reconnect it in a remote place.
• Connect your deskphone to the network (and plug in the power jack if you are using an external
power adapter).
• If the option to enter PIN code when you boot your deskphone is enabled in the VPN
configuration (Request Pin on Boot):
o The PIN code is requested.
o Enter PIN code.
o Validate.
o The phone starts as teleworker.
• If the option is not enabled (Request Pin on Boot).
o When the deskphone displays the 'Step 2' during the boot, repeatedly press the '*' and '#'
keys in succession until a menu is displayed.
o VPN VPN Config
o Enter your PIN code.
o Validate.
o Enable VPN: Enable the teleworker.
o / : Validate your choice.
o The deskphone restarts.
o Enter the PIN code if you have selected the option (Request Pin on Boot).
o Validate.
o The phone starts as teleworker.
If an error occurs when your phone is running in remote mode, a popup is displayed with an error
message. Please note this message to send to your administrator.
To Next Page
Loading...
