EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-16 - Page 277

Alcatel-Lucent 1830 PSS-16
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
No C-Band channels are detected leaving from (transmitted by) the amplifier SIG port,
but the NE has at least one service successfully launched and the amplifier link has been
successfully received.
Severity Critical
Service affecting? Yes
Applicability A2325A, AHPHG, AHPLG, ALPHG, ALPFGT, AM2017B,
AM2325B, OSCT
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
This alarm is the result of a problem internal to this NE.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Perform the procedure “Path Power Trace” (p. 3-8) to identify the probable network
trouble point for the lightpath. This will identify the cards and ports on this NE to look at
first during this procedure.
...................................................................................................................................................................................................
2
Identify the cards that are in the NE through path and confirm that all ports and cards on
the through path are administratively up
1. To examine the card state, enter the following command. Observe the admin state and
operational state of each of the cards along the THRU path:
CLI show slot *
2. Set any of the cards that are administratively down to up. To bring a card Admin Up:
CLI config slot shelf slot state up
Trouble-clearing procedures
ALLCHANMISS-OUT
ALLCHANMISS-OUT (C-Band Loss of signal)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-27

Table of Contents

Related product manuals