...................................................................................................................................................................................................
2
Determine what type of card is reporting the condition.
If... Then...
the card is a transponder card that is equipped
with a Wavelength Tracker encoder,
check to see that the fibering for that card is
correct. Remove the fiber from the Tx port on
the transponder card. If the condition clears
after 20 seconds, then this is a misfibering
problem.
the card is an SVAC, or if there is no fibering
problem on the transponder card,
continue with Step 3.
...................................................................................................................................................................................................
3
Confirm that replacement card supports the same band as the alarmed card.
...................................................................................................................................................................................................
4
Label all fibers connected to the alarmed card.
...................................................................................................................................................................................................
5
Disconnect all fibers on the alarmed card and cap the ends to protect them from dirt and
damage.
...................................................................................................................................................................................................
6
Replace the card. Refer to “Replacing System Components” (p. 3-20). Follow the return
and repair process in the Customer and Product Support guide to return the faulty card to
an authorized repair center for replacement.
...................................................................................................................................................................................................
7
Clean and connect all fibers to the replacement card.
...................................................................................................................................................................................................
8
Once the software on the card is successfully upgraded (this happens automatically), the
alarm should clear.
MTCESURVDGR
MTCESURVDGR (Port degrade - wavelength tracker encode
Trouble-clearing procedures
MTCESURV
MTCESURV (Add power control failure)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-200
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
