...................................................................................................................................................................................................
13
Reseat the card where the NET condition is present
...................................................................................................................................................................................................
14
Replace the card that is the source of the Ethernet signal.
...................................................................................................................................................................................................
15
Replace the card where the NET condition is present
Corrective Action
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Check that the source is operational up.
...................................................................................................................................................................................................
2
Check that the cable/fibre is plugged in correctly.
...................................................................................................................................................................................................
3
Check that the other end is plugged into a matching ethernet source (if this is an ALPHG
port, the matching source is another ALPHG port).
...................................................................................................................................................................................................
4
Check that cable/fibre is the correct type for the Ethernet port.
...................................................................................................................................................................................................
5
If a cable/fibre tester is available check that the cable/fibre is correct, otherwise try
another cable/fibre.
...................................................................................................................................................................................................
6
Perform a cold reset of the card.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
Note: Refer to Caution at the beginning of this procedure.
...................................................................................................................................................................................................
7
Refer to “Reseating a Card” (p. 3-19).
Trouble-clearing procedures
NET
NET (Link Down; Data Link Down)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-204
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
