Trail Trace Identifier Mismatch (Network Ports)
Severity Minor
Service affecting? No
Applicability 11QPA4, 43STX4, 4DPA4
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
Verify that the physical fibering between the network receive port of the transponder and
the output port of the SFD5, SFD44, or SFC2/4/8 is correct.
...................................................................................................................................................................................................
2
Perform the procedure “Determining the Far End of a Service” (p. 3-10) to determine the
NE and location of the transponder at the other end of this service.
...................................................................................................................................................................................................
3
Verify that the physical fibering between the network transmit port of the transponder and
the input port of the SFD5, SFD44, or SFC2/4/8 is correct.
...................................................................................................................................................................................................
4
Perform a warm reset of the card on the local card where the TIM condition is raised. If
the problem does not clear then perform a warm reset on the far-end card associated with
the local card raising the TIM condition.
CLI config card card type shelf slot reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
Trouble-clearing procedures
TIM
Trail Trace Identifier Mismatch (Network Ports)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-324
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
To Next Page
Loading...
