Procedure
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
The following procedure is recommended when you want to avoid a firmware upgrade
and use/retain a specific firmware version.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
CLI show firmware card
shelf slot
detail
Record the currently active firmware load (from the recently upgraded
release) as
active-release
WEBUI Select the card, click the Firmware tab, and view the Active Release field.
...................................................................................................................................................................................................
2
Establish a particular release for the instance of the card in your system.
CLI config firmware card
shelf slot active-release
WEBUI Enter the desired release in the Provisioned Release field.
The system will reload this specific version rather than the default recommended version
on any subsequent cold reset of that card.
...................................................................................................................................................................................................
3
Perform a warm reset of the card.
CLI config card
card type shelf slot
reset warm
WEBUI Select the card, click the Reboot tab, select Warm Reboot >Submit.
This action will restart the software on the card (nonservice affecting), clearing the
FWUPGRADEPENDING condition.
Supporting procedures
Firmware
Selecting a Specific Firmware Version
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
3-15
To Next Page
Loading...
