Log Command Reference
260 7705 SAR OS System Management Guide
Accounting Policy Commands
accounting-policy
Syntax accounting-policy policy-id [interval minutes]
no accounting-policy policy-id
Context config>log
Description This command creates an access accounting policy.
An accounting policy defines the accounting records that are created.
Access accounting policies are policies that can be applied to one or more service access points (SAPs).
Changes made to an existing policy, using any of the sub-commands, are applied immediately to all
SAPs where this policy is applied.
If an accounting policy is not specified on a SAP, then accounting records are produced in accordance
with the access policy designated as the default. For more information, see the default command.
The no form of the command deletes the policy from the configuration. The accounting policy cannot
be removed unless it is removed from all the SAPs or channels where the policy is applied.
Default No default accounting policy is defined.
Parameters policy-id — the policy ID that uniquely identifies the accounting policy, expressed as a decimal
integer
Values 1 to 99
minutes — the interval, in minutes, in which statistics are collected and written to their destination
The default interval for each record type is defined in the record record-name description.
Values 5 to 120
Default as defined in the record name description
default
Syntax [no] default
Context config>log>accounting-policy
Description This command adds the designation that the accounting policy ID is the default access accounting
policy to be used with all SAPs without a specified accounting policy.
If no access accounting policy is defined on a SAP, accounting records are produced in accordance
with the default access policy. If no default access policy is created, no accounting records will be
collected other than the records for the accounting policies that are explicitly configured.
To Next Page
Loading...
