Alcatel-Lucent 7750 - Configuring Physical Ports with CLI

Interface Configuration
7750 SR Interface Configuration Guide Page 177
Configuring Physical Ports with CLI
This section provides information to configure cards, MDAs, and ports.
Topics in this section include:
• Preprovisioning Guidelines on page 179
→ Predefining Entities on page 179
→ Preprovisioning a Port on page 180
→ Maximizing Bandwidth Use on page 181
• Basic Configuration on page 182
• Common Configuration Tasks on page 185
→ Configuring Ports on page 192
→ Configuring LAG Parameters on page 255
• Common Configuration Tasks on page 185
→ Configuring Cards and MDAs on page 186
→ Configuring Cards, MDA Carrier Modules (MCMs) and Media Dependent Adapters
(MDAs) on page 187
− Configuring MDA/CMA Access and Network Pool Parameters on page 190
→ Configuring Ports on page 192
− Configuring Port Pool Parameters on page 192
− Changing Hybrid-Buffer-Allocation on page 195
− Configuring APS Parameters on page 195
− Configuring Ethernet Port Parameters on page 197
− Configuring SONET/SDH Port Parameters on page 199
− Configuring Channelized Ports on page 202
− Configuring Cpipe Port Parameters on page 222
− Configuring ATM SAPs on page 224
− Configuring DWDM Port Parameters on page 225
− Configuring OTU Port Parameters on page 231
− Configuring ATM Interface Parameters on page 233
− Configuring Frame Relay Parameters on page 239
− Configuring Multilink PPP Bundles on page 243
− Configuring Multilink ATM Inverse Multiplexing (IMA) Bundles on page 244
− Configuring Bundle Protection Group Ports on page 249
→ Configuring LAG Parameters on page 255
− Configuring BFD on LAG Links on page 255