Alcatel-Lucent 7750 - Configuring Forwarding Plane Parameters

Interface Configuration
7750 SR Interface Configuration Guide Page 189
Configuring Forwarding Plane Parameters
The following output provides a forwarding plane configuration. The fp command is not allowed
on iom-1 or iom-2 types. An error message appears when the command is executed on an
incorrect IOM type:
MINOR: CLI This command is not supported for iom2-20g.
*A:Dut-C# configure card 10
*A:Dut-C>config>card# info
----------------------------------------------
card-type iom3-xp
fp 1
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
mda 1
mda-type m1-10gb
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
mda 2
mda-type m2-10gb-xfp
ingress
mcast-path-management
bandwidth-policy "BWP"
no shutdown
exit
exit
exit
----------------------------------------------
*A:Dut-C>config>card# exit