Alcatel-Lucent 7750 - Frame Relay Commands

Interfaces
Page 472 7750 SR Interface Configuration Guide
Frame Relay Commands
frame-relay
Syntax frame-relay
Context config>port>sonet-sdh>path
config>port>tdm>ds1>channel-group
config>port>tdm>ds3
config>port>tdm>e1>channel-group
config>port>tdm>e3
Description This command allows access to the context to configure the Frame Relay Local Management Interface
(LMI) operational parameters for a SONET/SDH PoS link, a DS-0 channel group, or a DS-3/E-3 port or
channel.
The port’s mode must be set to access in config>port>sonet-sdh>path>mode access context.
The port’s encapsulation type must be set to frame-relay in the config>port>sonet-sdh>path>encap-type
frame-relay context.
The no form of this command removes the Frame Relay LMI operational parameters.
frf-12
Syntax [no] frf-12
Context config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>e1>channel-group>frame-relay
config>port>tdm>ds3>frame-relay
config>port>tdm>e3>frame-relay
config>port>sonet-sdh>path>frame-relay
Description This command defines the context to configure the parameters of FRF.12 Frame Relay fragmentation.
egress
Syntax egress
Context config>port>multilink-bundle>mlfr
config>port>tdm>ds1>channel-group>frame-relay
config>port>tdm>e1>channel-group>frame-relay>frf-12
config>port>tdm>ds3>frame-relay>frf-12
config>port>tdm>e3>frame-relay>frf-12
config>port>sonet-sdh>path>frame-relay>frf-12