Alcatel-Lucent 7750 - Configuring Channelized STM1;OC3 Parameters

Interfaces
Page 220 7750 SR Interface Configuration Guide
Configuring Channelized STM1/OC3 Parameters
The following example displays basic syntax to configure channelized STM1/OC3 parameters:
CLI Syntax: config# port port-id
sonet-sdh
framing {sonet|sdh}
group sonet-sdh-index payload {tu3|vt2|vt15}
path [sonet-sdh-index]
payload {sts3|tug3|ds3|e3}
trace-string [trace-string]
no shutdown
Example
: config# port 5/2/1
config>port# sonet-sdh
config>port>sonet-sdh# framing sdh
config>port>sonet-sdh# path sts3
config>port>sonet-sdh>path# trace-string "HO-path"
config>port>sonet-sdh>path# exit
config>port>sonet-sdh# group tug3-1 payload vt2
config>port>sonet-sdh# group tug3-3 payload vt2
config>port>sonet-sdh# path vt2-1.1.1
config>port>sonet-sdh>path# trace-string "LO-path 3.7.3"
config>port>sonet-sdh>path# no shutdown
config>port>sonet-sdh>path# exit
config>port>sonet-sdh# exit
config>port# tdm
config>port>tdm# e1 1.1.1
config>port>tdm>e1# channel-group 1
config>port>tdm>e1>channel-group# timeslots 2-32
config>port>tdm>e1>channel-group# no shutdown
config>port>tdm>e1>channel-group# exit
config>port>tdm>e1# exit
config>port>tdm# e1 3.7.3
config>port>tdm>e1# channel-group 2
config>port>tdm>e1>channel-group# timeslots 2-32
config>port>tdm>e1>channel-group# no shutdown
config>port>tdm>e1>channel-group# exit