Alcatel-Lucent 7750 - Getting Started; Alcatel-Lucent 7750 SR Router Configuration Process; Table 2: Configuration Process

Alcatel-Lucent 7750 SR Router Configuration Process
Page 18 7750 SR Interface Configuration Guide
Alcatel-Lucent 7750 SR Router Configuration Process
Table 2 lists the tasks necessary to provision input/output control modules (IOMs), also referred to
as cards, Media Carrier Modules (MCMs), Media Dependent Adapters (MDAs),and ports.
This guide is presented in an overall logical configuration flow. Each section describes a software
area and provides CLI syntax and command usage to configure parameters for a functional area.
Note: In SR OS any function that displays an IPv6 address or prefix changes to reflect rules
described in RFC 5952, A Recommendation for IPv6 Address Text Representation. Specifically,
hexadecimal letters in IPv6 addresses are now represented in lowercase, and the correct
compression of all leading zeros is displayed. This changes visible display output compared to
previous SR OS releases. Previous SR OS behavior can cause issues with operator scripts that use
standard IPv6 address expressions and with libraries that have standard IPv6 parsing as per RFC
5952 rules. See the section on IPv6 Addresses in the Router Configuration Guide for more
information.
Table 2: Configuration Process
Area Task Chapter
Provisioning Chassis slots and cards Chassis Slots and Cards on page 21
MCMs MCMs on page 22
MDAs MDAs on page 22
Versatile Service Module Versatile Service Module (VSM) on page 25
Ports Ports on page 37
Reference List of IEEE, IETF, and other
proprietary entities.
Standards and Protocol Support on page 773