Interface Configuration
7750 SR Interface Configuration Guide Page 259
Service Management Tasks
This section discusses basic procedures of the following service management tasks:
• Modifying or Deleting an MDA, MCM, or CMA on page 259
• Modifying a Card Type on page 260
• Deleting a Card on page 261
• Deleting Port Parameters on page 261
Modifying or Deleting an MDA, MCM, or CMA
To change an MDA or CMA type already provisioned for a specific slot/card, first you must shut
down the slot/MDA/port configuration and then delete the MDA, CMA, and/or the MCM from the
configuration.
Note: To modify or delete CMAs, use the MDA command structure.
Use the following CLI syntax to modify an MDA:
CLI Syntax: config> port port-id
shutdown
CLI Syntax: config> card slot-number
shutdown
[no] mda mda-number
[no] mda-type mda-type
[no] hi-bw-mcast-src [alarm] [group group-id]
shutdown
Note: It is not required to shutdown and remove an MCM to remove or modify an MDA. Use the
following sequence if changing the MCM type or slot configuration.
CLI Syntax: config> card slot-number
shutdown
[no] mcm mcm-number
no mcm-type mcm-type
shutdown
To Next Page
Loading...
