Interface Configuration
7750 SR Interface Configuration Guide Page 311
The no form of the command converts the pool mode on the IOM card to the default mode. If MDAs are
currently provisioned on the IOM, the card is reset.
named-pool-mode
Syntax named-pool-mode
Context config>card>mda
config>port
Description The named-pool-mode CLI context is used to store the MDA and port level named pool mode configuration
commands. Currently, only the ingress and egress named-pool-policy commands are supported. Any future
named pool mode configuration commands or overrides will be placed in the named-pool-mode CLI con-
text. Within the context is an ingress and egress context.
Enter the named-pool-mode to define the ingress and egress named pool policy associations for either an
MDA or port. The node may be entered regardless of the current named-pool-mode state of the IOM.
To Next Page
Loading...
