Interfaces
Page 322 7750 SR Interface Configuration Guide
path-limit
Syntax path-limit megabits-per-second
no path-limit
Context config>card>mda>ingress>mcast-mgmt>anc-override
Description This command overrides the path limits contained in the bandwidth policy associated with the MDA.
The no form of the command removes the path limit override from an ingress multicast path and restores the
path limit defined in the bandwidth policy associated with the MDA.
Parameters megabits-per-second — Specifies the path limit override to give the upper limit that multicast channels may
use on each path.
Values ancillary-override: 1 — 5000
primary-override: 1 — 2000
secondary-override: 1 — 2000
bandwidth-policy
Syntax bandwidth-policy policy-name
no bandwidth-policy
Context config>card>mda>ingress>mcast-mgmt
Description This command specifies an existing multicast bandwidth policy. Bandwidth policies are used to manage the
ingress multicast path bandwidth. Each forwarding plane supports multicast forwarding paths into the
switch fabric. Bandwidth policy parameters are configured in the config>mcast-mgmt context.
Parameters policy-name — Specifies an existing multicast bandwidth policy.
primary-override
Syntax primary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure primary path limit override parameters.
secondary-override
Syntax secondary-override
Context config>card>mda>ingress>mcast-mgmt
Description This command enables the context to configure secondary path limit override parameters.
To Next Page
Loading...
