Interface Configuration
7750 SR Interface Configuration Guide Page 337
Parameters power — Specify the desired average output power in dBm.
Values -22.00 — 3.00
target-power
Syntax target-power power
Context config>port>dwdm>coherent
Description This command configures the target transmit optical power for the port.
Default 1.00 dBm
Parameters power — Specify the desired average output power in dBm.
Values -20.00 — 1.00
report-alarm
Syntax [no] report-alarm [encode-fail] [encode-degrade] [power-fail] [power-degrade] [power-high]
[power-low]
Context config>port>dwdm>wavetracker>
Description This command specifies the alarms which are enabled or outstanding against a Wave Tracker-enabled inter-
face.
The no form of the command removes the alarm parameters.
Values encode-fail — Encoder failure
encode-degrade — Encoder degrade
power-fail — Power control failure
power-degrade — Power control degrade
power-high — Power control high limit reached
power-low — Power control low limit reached
encode
Syntax encode wave-key key2 wave-key
no encode
Context config>port>dwdm>wavetracker
Description This command specifies whether or not Wavetracker keys should be encoded on the transmitted optical sig-
nal.
Default no encode
Parameters wave-key — The wave-key values must be selected based on the currently configured DWDM ITU channel.
To Next Page
Loading...
