Interface Configuration
7750 SR Interface Configuration Guide Page 343
mtl — Reports module case temperature low faults.
unlck — Reports thermal control locked faults.
tlim — Reports thermal control temperature limit faults.
einv — Reports EEPROM invalid faults.
com — Reports Tdcm module communication failure faults.
report-alarms
Syntax [no] report-alarms [modflt] [mod] [netrx] [nettx] [hosttx]
Context config>port>dwdm>coherent
Description This command configures the alarms that will be reported for the coherent module.
Default modflt mod netrx nettx hosttx
Parameters modflt — Reports module fault alarm.
mod — Reports module alarm.
netrx — Reports network (optical side) receive alarm.
nettx — Reports network (optical side) transmit alarm.
hosttx — Reports host (electrical side) transmit alarml.
rx-los-thresh
Syntax rx-los-thresh <threshold>
Context config>port>dwdm>coherent
Description This command configures the average input power LOS (Loss of Signal) threshold.
Default -23
Parameters threshold — Specifies port’s rx los threshold.
Values -23.00 — -13.00
sweep
Syntax sweep start dispersion-start end dispersion-end
Context config>port>dwdm>tdcm
Description This command allows users to configure the dispersion sweep ‘start’ and ‘end’ values for the automatic
mode of TDCM control. If the user knows the approximate or theoretical residual dispersion of the link, this
To Next Page
Loading...
