Alcatel-Lucent 7750 - Page 376

Interfaces
Page 376 7750 SR Interface Configuration Guide
===============================================================================
Description : OC-48 SONET/SDH
Interface : 2/2/2 Speed : oc48
Admin Status : up Oper Status : up
Physical Link : Yes Loopback Mode : none
Single Fiber Mode : No
APS Group : none APS Role : none
Clock Source : loop Framing : sonet
Last State Change : 04/11/2007 14:53:53 Port IfIndex : 37814272
J0 String : 0x01 Section Trace Mode : byte
Rx S1 Byte : 0x00 (stu) Rx K1/K2 Byte : 0x00/0x00
Tx S1 Byte : 0x0f (dnu) Tx DUS/DNU : disabled
Rx J0 String (Hex) : af 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Cfg Alarm : loc lrdi lb2er-sf slof slos
Alarm Status :
Hold time up : 500 milliseconds
Hold time down : 0 milliseconds
Transceiver Data
Transceiver Type : SFP
Model Number : SFP-OC48-SR1
Transceiver Code : OC48 SR
Laser Wavelength : 1310 Diag Capable : yes
Connector Code : LC Vendor OUI : 00:01:9c
Manufacture date : 2004/08/20 00:00:00 Media : SONET/SDH
Serial Number : 6331000705
Part Number : CT2-MS1LBTD32Z2
Optical Compliance*: 00:01:00:00:00:00:00:00
Link Len 9u : 2 kms Link Len Cu : 0 m
Link Len 9u : 20 * 100m Link Len 62.5u : 0 * 10m
Link Len 50u : 0 * 10m
===============================================================================
Port Statistics
===============================================================================
Input Output
-------------------------------------------------------------------------------
Packets 3870094 6656408
Discards 0 0
Unknown Proto Discards 0
===============================================================================
A:NS044050253#
wtr-annexb
Syntax wtr-annexb minutes
Context config>port>aps
Description This command waits to restore for Annex B mode operation. The delay after which the newly active section
becomes the primary section after a switch-over from the primary section to the secondary section occurs
and the switch request clears normally.
Parameters minutes — Specify the time, in minutes, to wait to restore for Annex B mode operation