Alcatel-Lucent 7750 - Page 411

Interface Configuration
7750 SR Interface Configuration Guide Page 411
multiplier multiplier — Specifies the multiplier for transmit-interval to set local link down timer.
Values 2 — 5
tunneling
Syntax [no] tunneling
Context config>port>ethernet>efm-oam
Description This command enables EFM OAM PDU tunneling. Enabling tunneling will allow a port mode Epipe SAP to
pass OAM frames through the pipe to the far end.
The no form of the command disables tunneling.
Default no tunneling
egress-rate
Syntax egress-rate sub-rate
no egress-rate
Context config>port>ethernet
Description This command configures the rate of traffic leaving the network.
The no form of this command returns the value to the default.
Default no egress-rate
Parameters sub-rate — The egress rate in Kbps.
Values 1 — 10000000
encap-type
Syntax encap-type {dot1q | null | qinq}
no encap-type
Context config>port>ethernet
Description This command configures the encapsulation method used to distinguish customer traffic on an Ethernet
access port, or different VLANs on a network port.
The no form of this command restores the default.
Default null
Parameters dot1q — Ingress frames carry 802.1Q tags where each tag signifies a different service.
null — Ingress frames will not use any tags to delineate a service. As a result, only one service can be con-