Interfaces
Page 418 7750 SR Interface Configuration Guide
qinq-etype
Syntax qinq-etype 0x0600..0xffff
no qinq-etype
Context config>port>ethernet
Description This command configures the Ethertype used for Q-in-Q encapsulation.
The no form of this command reverts the qinq-etype value to the default.
Parameters 0x0600..0xffff — Specifies the qinq-etype to expect.
Values 1536 — 65535 in decimal or hex formats.
report-alarm
Syntax [no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [lcd]
Context config>port>ethernet
Description This command specifies when and if to generate alarms and alarm clear notifications for this port.
Parameters signal-fail — Reports an Ethernet signal lost alarm.
remote — Reports remote faults.
local — Reports local faults.
no-frame-lock — Reports a 'not locked on the ethernet framing sequence' alarm.
lcd — Reports a codegroup delineation error.
sflow
Syntax [no] sflow
Context config>port>ethernet
Description This command enables sFlow data collection for a port and its SAPs that support sFlow data collection.
The no form of this of this command disables sFlow.
Default no sflow
single-fiber
Syntax [no] single-fiber
Context config>port>ethernet
To Next Page
Loading...
