Interfaces
Page 438 7750 SR Interface Configuration Guide
member
Syntax [no] member port-id
Context config>port>multilink-bundle
Description This command binds a channel group to a multilink bundle. For IMA and MLFR groups, this command
binds a channel group filling up the entire DS-1 or E-1. For MLPPP groups, fractional (n x ds0) DS1 or E1
links are also allowed. However, fractional DS1 links and fractional E1 links may not be combined in the
same multilink bundle. If a channel with a different number of timeslots than the primary-link member is
added to the bundle, a warning will be provided.
The no form of this command removes the specified channel group from the multilink bundle.
Default None
Parameters port-id — Specifies the physical port ID.
Syntax: slot/mda/port.channel
minimum-links
Syntax minimum-links minimum-links
no minimum-links
Context config>port>multilink-bundle
Description This command sets the minimum number of links that must be active for the bundle to be active.
If the number of active links drops below the configured minimum then the multilink bundle will transition
to an operationally down state.
The no form of this command removes the minimum link limit.
Default 1
Parameters minimum-link — Specify the minimum link limit, expressed as an integer.
Values 1 — 8
mlfr
Syntax mlfr
Context config>port>multilink-bundle
Description This command enables the context to configure a Multi-link Frame Relay (MLFR) bundle.
To Next Page
Loading...
